| |
 |
| |
| |
|
|
|
|
| |
Uffici NUOVA
OMEC
Via Guatelli, 13/15
41043 Formigine -
Modena (Italy)
Ph. +39 059.556844
Fax. +39 059.558670
e-mail info@nuovaomec.it
|
|
|
The
right ROLL
for
all your requirements! |
  |
|
|
|
|
 |
|
Home>Products>BELT
GUIDE ROLLERS LMGN SERIES
BELT GUIDE ROLLERS LMGN SERIES
|
|
Use:
in carriers where the belt run needs to be contained
within predetermined parameters.
Characteristics:
steel rollers, assembled on ball bearings 6202, 13 hole. Supplied
in those versions with permanent lubrication and they have the possibility of
being utilised in identical operating temperatures to those foreseen for the
LM series. On the superior end of these rollers a hermetic protection can be
found. The belt guide rollers are fixed to the edges of the carrier via the exit
point of the threaded shaft.
On request:
they may be supplied with rubber covering (10
mm thickness) to guard against excessive friction on the
side of the belt, thus reducing wear and tear.
ON REQUEST
SERIES LP.GN – LMT.GN - LEP.GN
Use:
in carriers utilised in installations where operation
under extreme conditions is required, and where belt
run needs to be retained within the foreseen parameters.
Characteristics:
steel rollers of considerable thickness,
assembled on rigid radial single ball bearings. Supplied
only with those versions with permanent lubrication
and they have the possibility of being utilised in
operating temperatures equal to those of the LP, LMT
and LEP series.
On the superior ends of these rollers a hermetic protection
can be found. They are fastened to the edges of the carrier
via the exit point of the threaded shaft.
|
| |
|
|
|
|
|
